Door jamb label for tyre pressures – Renault Clio 16S (1991-1992)

The “Pression de gonflage pneus froids” (cold tyre pressures) label from the driver's door of 1991-1992 Clio 16S models.

Stuck on the driver's door shut, this label shows the cold tyre pressures. Our reproduction follows the original layout, with laminated high-definition printing.

Contents

• 1 “Pression de gonflage pneus froids” decal

Good to know

• Pressures shown: front 2.0 bar / rear 2.2 bar.
• Also included in the set of 9 technical decals for the Clio 16S.

Also available

• Set or single (16S 1991): Set of 9 (1991) — 9 interior door engine compartment stickers for Renault Clio 16S phase 1 1991
• Set or single (16S 1991): Elf — "Renault Recommends ELF" Sticker - Engine Compartment - Renault Clio Williams, 16S, R5, R11, R18, R19, R21, R25, 4L, Alpine...
• Set or single (16S 1991): Battery — Renault "Important Battery" Sticker for R5 GT Turbo 5 Alpine R18 R11 R19 R21 R25 4L Engine
• Set or single (16S 1991): Coolant — Renault Coolant Sticker for R5 GT Turbo 5 Alpine Clio 16S R19 R21 R25 Engine
• Set or single (16S 1991): Headlamps 1.20% — Headlight Tilt Sticker "1.20%" Engine Compartment - Renault Clio Williams, 16S & 16V
• Set or single (16S 1991): Fuel — Renault Clio 16S 16V Unleaded 95 98 Door Sticker
• Set or single (16S 1991): Genuine parts — Renault "Demand Original Parts" Sticker for Clio 16S Phase 1 Engine
• Set or single (16S 1991): Bulb protector — "Bulb Protector" Sticker for Power Steering Reservoir, Engine Compartment - Renault Clio Williams, 16S & 16V

At a glance

• STICK-IN reference: STK-100-033
• Vehicle(s): Clio 16S - 16V - CUP
• Location: Cabin - Door sills
• Colour: Multicoloured (printed)
• Material: High-definition printed vinyl (UV-resistant inks), laminated and pre-cut to shape
• Transfer tape: no, one-piece decal
• Manufacturing: made to order in our workshop in France — shipped within 3 to 7 days (excluding Saturdays, Sundays, public holidays and annual closure)

Fitting tips

Clean and degrease the surface thoroughly (isopropyl alcohol or a mild degreaser), then let it dry: it must be clean, smooth and dry, ideally between 15 and 25 °C.

Peel the decal from its backing sheet by one edge, position it, then apply it from the centre outwards to push out any air.

Fitting instructions are included with every order.

Faithful reproduction made by STICK-IN, a French workshop specialising in car restoration decals since 2015. This is not an original manufacturer part: above all, we are enthusiasts.