Door jamb label for tyre pressures – Renault Clio Williams, 16S/16V (except 1991)

The tyre pressure label from the driver's door of the Clio Williams.

Stuck inside the left-hand door of the Clio Williams and 16S/16V (except 1991), it shows the recommended cold tyre pressures. A must for a car shown at a concours or a meet, it is faithfully reproduced here.

Contents

• 1 “Pressions de gonflage pneus froids” (cold tyre pressures) decal (front 2.0 – 2.2 bar / rear 2.0 – 2.2 bar)

Good to know

• Also included in our set of 9 technical decals.

Also available

• Set or single (1992 onwards): Set of 9 — Set of 9 engine compartment and door interior stickers - Renault Clio Williams, 16S & 16V (except 1991)
• Set or single (1992 onwards): Elf — "Renault Recommends ELF" Sticker - Engine Compartment - Renault Clio Williams, 16S, R5, R11, R18, R19, R21, R25, 4L, Alpine...
• Set or single (1992 onwards): Battery — "Demand Original Part" sticker - Battery - Engine Compartment - Renault Clio Williams, 16S & 16V (except 1991)
• Set or single (1992 onwards): Coolant warning — "Caution: Coolant" sticker - Engine compartment - Renault Clio Williams, 16S & 16V (except 1991)
• Set or single (1992 onwards): Headlamps 1.20% — Headlight Tilt Sticker "1.20%" Engine Compartment - Renault Clio Williams, 16S & 16V
• Set or single (1992 onwards): Fuel — Fuel sticker "Unleaded 95 98" Driver's door - Renault Clio Williams, 16S & 16V (except 1991)
• Set or single (1992 onwards): Type D — "Type D" Coolant Reservoir Sticker - Engine Compartment - Renault Clio Williams, 16S & 16V (except 1991)
• Set or single (1992 onwards): Bulb protector — "Bulb Protector" Sticker for Power Steering Reservoir, Engine Compartment - Renault Clio Williams, 16S & 16V

At a glance

• STICK-IN reference: STK-100-802
• Vehicle(s): Clio Williams, Clio 16S - 16V - CUP
• Location: Cabin - Door sills
• Colour: Multicoloured (printed)
• Material: High-definition printed vinyl (UV-resistant inks), laminated and pre-cut to shape
• Transfer tape: no, one-piece decal
• Manufacturing: made to order in our workshop in France — shipped within 3 to 7 days (excluding Saturdays, Sundays, public holidays and annual closure)

Fitting tips

Clean and degrease the surface thoroughly (isopropyl alcohol or a mild degreaser), then let it dry: it must be clean, smooth and dry, ideally between 15 and 25 °C.

Peel the decal from its backing sheet by one edge, position it, then apply it from the centre outwards to push out any air.

Fitting instructions are included with every order.

Faithful reproduction made by STICK-IN, a French workshop specialising in car restoration decals since 2015. This is not an original manufacturer part: above all, we are enthusiasts.